Cutting Tree Roots: How Close to the Trunk Is Safe?

Michael Kahn, Sacramento homeowner and lifelong gardener
Michael Kahn
11 min read
Thick buttress roots spreading out from the base of a large tree across a lawn beside a red brick building

Cutting a tree root usually won’t kill the tree. Where you cut it decides what happens next. A root cut out past the edge of the canopy costs the tree a little water for a season, and the tree grows new roots at the cut. A thick root cut a couple of feet from the trunk is a different story, because that is the root holding the tree up. Iowa State Extension puts the working line at three times the trunk’s diameter: don’t cut buttress roots any closer than that, and if a cut has to come within 1.5 times the diameter, removing the tree is the safer call.

The same line applies whoever did the cutting, whether it was a fence crew trenching along the property line, a city crew grinding out roots to repave the sidewalk, or a neighbor widening a driveway. If the work hasn’t started yet, you can still keep most of those roots in the ground.

Where are a tree’s roots?

Much shallower and much wider than most people picture. The majority of a tree’s roots sit in the top 12 to 18 inches of soil, according to Iowa State Extension, and fewer than 2 percent of landscape trees have a taproot at all, per Colorado State Extension.

Soil type changes the picture, and this part matters if you garden on Sacramento Valley clay. Colorado State’s numbers:

SoilRoots in the top layerHow far roots spread
Good, loose soil90-95% in the top 36 inches2-3 times the tree’s height or canopy spread
Compacted or clay soil90-95% in the top 12 inches5 or more times the tree’s height

So a tree in heavy clay keeps almost everything in the top foot and reaches farther sideways to make up for it. A trench 18 inches deep cuts through nearly all of it.

Close-up of tree roots running through dark soil

One more myth to drop: the idea that the “feeder roots” sit in a ring at the drip line. Iowa State’s extension horticulturists call that a common misconception. Absorbing roots run all through the root zone and well past the canopy edge.

How close to the trunk can you cut a root?

This is where most of the risk sits, and there’s newer research on it than most tree advice reflects.

In a 2025 study published in Arboriculture & Urban Forestry, researchers dug trenches at three distances from young red maples and then pulled the trees sideways to measure how much force they could take. The trench distance is measured in multiples of the trunk diameter (DBH):

Trench distance from trunkRoots lostDrop in bending resistance
1 times trunk diameter13.3%45.2%
3 times trunk diameter4.1%35.2%
5 times trunk diameter2.5%22.3%

Look at the middle row. Losing about 4 percent of the roots cost the tree more than a third of its ability to resist being pushed over. The authors put it plainly: “even a small volume of root loss can meaningfully reduce tree stability.”

The other rules you’ll run into all come from different starting points, and they don’t agree:

  • Iowa State Extension: no buttress-root cuts inside 3 times the trunk diameter, measured 3 feet up. At 1.5 times or closer, consider removing the tree.
  • The Morton Arboretum: a protection zone with a radius of 1 foot per inch of trunk diameter, and no disturbance at all inside half that distance.
  • Purdue Extension: a critical root radius of 1.5 feet per inch of trunk diameter. A 16-inch trunk gets a 24-foot radius.
  • Colorado State Extension: keep trenches at least 8 feet from the trunk, and for trees planted more than four years ago, protect the drip line plus 1 foot for every inch of trunk diameter.

Here’s how I’d use them. Treat 3 times the trunk diameter as the hard floor for any cut. Aim for 5 times or more if the tree is big enough to land on something you care about. Use Purdue’s 1.5 feet per inch when you’re planning new work and still have room to move it.

Long utility trench dug through bare soil at a suburban construction site

Why can a tree fall over before it looks sick?

Two different things go wrong when roots get cut, and they show up on different schedules.

Cutting the thick structural roots near the trunk is a stability problem. Colorado State calls the area within 3 to 6 trunk diameters the root plate, the part that anchors the tree, and says it should not be disturbed. A tree with its root plate cut can keep a full green canopy right up until the windstorm that tips it. Cutting roots on both sides is worse: one study summarized in a 2014 research review found that severing roots on two sides cut the force needed to topple the tree by two-thirds.

Cutting the small absorbing roots farther out is a health problem. The tree loses water and nutrient uptake, and it declines slowly: thinner leaves, dieback from the top, a few bad years.

That’s why a tree that “looks fine” a month after the fence went in tells you nothing about the cut 2 feet from the trunk.

How much of the root system can a tree lose?

Less than the canopy suggests. Purdue Extension says not to let more than 25 percent of the roots in the protected root zone be damaged. Colorado State says decline and death can follow when more than 40 percent of the roots are damaged, and recommends preserving at least half the root system.

Root size is the other limit. Iowa State says to avoid cutting roots over 2 inches in diameter. Oregon State Extension draws the line at 4 inches, because roots that thick are likely structural and cutting one risks the tree failing outright.

Which trees handle root cutting best?

Species matter, and older trees take it harder than young ones. Colorado State Extension groups common trees by how well they adapt to construction damage:

  • High: American elm, common hackberry, cottonwood, ginkgo, green ash, honeylocust, London planetree, silver maple, willow
  • Moderate: bur oak, Kentucky coffeetree, linden, Norway maple, pine, serviceberry, white oak
  • Low: black locust, Colorado blue spruce, English oak, northern red oak, Norway spruce, poplar

The sources don’t all agree. The Morton Arboretum lists white oak among the most sensitive trees, alongside red oak and sugar maple, and puts poplars in its tolerant group, the opposite of Colorado State. Oaks deserve extra caution either way: in one long-term study summarized in the 2014 review, roots cut within half a meter of the trunk led to decay in the trunks of some black and white oaks four years later, while red maples cut the same way showed none.

If your tree is a mature oak, and in the Sacramento area it often is, treat any cut near it as an arborist’s call.

How do you cut a tree root the right way?

If a root has to go, the way it’s cut makes a real difference to how the tree recovers.

  • Expose it by hand first. Iowa State is blunt about this: “make clean cuts with a saw or hand pruners (instead of ripping them off with a backhoe).” A trencher or excavator tears roots and shatters them back toward the trunk.
  • Cut cleanly and squarely. Purdue calls for clean cuts perpendicular to the direction the root grows. A sharp folding saw like the Silky GomBoy handles roots up to a couple of inches without much fuss.
  • Don’t let the cut ends dry out. Purdue says to backfill within an hour of cutting and water the tree within 24 hours.
  • Then leave it alone. Trees grow new roots right at or just behind a clean cut, often within weeks in warm soil, according to the 2014 review. Decay from a cut usually stops within about 4 inches of the cut end, oaks being the exception noted above.

Tunnel, bend, or bridge instead of cutting

The best root cut is the one that never happens. Before anyone trenches, ask about these:

  • Bore under the roots. Oregon State says to tunnel or bore at least 18 inches beneath the critical root zone instead of trenching through it. The Morton Arboretum notes that augering under roots costs more and can decide whether the tree survives.
  • Use posts instead of footings. For fences, decks and additions, posts and piers leave most roots intact where a continuous footing or wall cuts every one in its path, per Clemson Extension and the Arbor Day Foundation.
  • Bend the line. The Arbor Day Foundation points out that a utility line doesn’t have to run straight from the street to the house: “There is nothing sacred about straight lines!”
  • Narrow or bridge the sidewalk. Iowa State suggests rerouting or narrowing a sidewalk (at least 39 inches wide for accessibility), ramping over roots at no more than a 1:20 slope, or switching to flexible pavers.

If the sidewalk fight is the reason you’re reading this, our list of trees to plant near the sidewalk covers what to put in next time.

How long until you know if the tree will make it?

Longer than anyone wants. The Morton Arboretum says symptoms may show the next growing season or take 2 to 3 years. Iowa State says construction damage may not be evident for 8 to 10 years, and one study cited in the 2014 review tracked dieback for 12 years after trenching through street-tree roots.

The signs to watch for, from the Morton Arboretum and Oregon State:

  • dieback starting at the top of the crown and the branch tips
  • leaves that come in smaller, sparser or yellow
  • sprouts along the trunk and big branches
  • dead twigs, then dead limbs

If you see those, our guides to the signs of a dying tree and how to revive a dying tree pick up from there. A tree that starts leaning after root work is an emergency. Call an arborist that week.

What to do after the roots are cut

  • Water deeply and slowly. The Morton Arboretum says to water the whole root zone until the top 8 to 12 inches are moist, and to start before symptoms appear. Oregon State’s number is at least 1 inch of water a week when rain falls short, which in a Sacramento summer means every week. A TreeGator watering bag works on younger trees; a mature tree needs a soaker hose run out across the root zone.
  • Mulch. Spread 3 to 4 inches of wood chips as far out as you can, kept off the trunk. Our guide to mulching a tree covers the details.
  • Skip the fertilizer. The Morton Arboretum and Purdue both advise against fertilizing a mature tree after root damage unless it shows a real deficiency.
  • Prune only what dies. Colorado State says to wait and see which branches die back before pruning, and not to thin the crown ahead of time.
  • Keep everything off the roots. No parked cars, stacked materials or equipment over the root zone. The Morton Arboretum warns that a single pass of heavy equipment can damage soil and roots for good.

Before the contractor shows up

If the work is still in the planning stage, you have leverage. Use it.

  1. Measure the trunk and mark the protection zone with Purdue’s 1.5 feet per inch of trunk diameter. A 12-inch trunk gets an 18-foot radius.
  2. Fence the zone for the whole job. Purdue suggests construction fence, snow fence or chain link with signs; the Arbor Day Foundation notes that plastic mesh is cheap but crews tend to ignore it.
  3. Cover access routes. If equipment must cross the root zone, Purdue says to lay at least 6 inches of wood chip mulch over the route, or use steel plates.
  4. Keep concrete washout and fuel away from the roots. Concrete washout is caustic, per Purdue.
  5. Get an arborist involved early. Purdue’s line is worth repeating: “Too often, the tree professional is called too late when the damage has been done.” An ISA-certified arborist can mark the zone, approve the route and supervise any root cuts. Our page on what an arborist does covers credentials, and MK Library has a good checklist on choosing an arborist.
  6. Call 811 at least two business days before anyone digs, so buried utilities get marked.

If the roots belong to a neighbor’s tree, or the contractor works for your neighbor, who may cut what is a legal question that depends on your state and city. Talk to the neighbor first, and to an attorney if it comes to that.

And if the tree turns out to be too far gone, our tree removal cost guide covers what that runs.

Frequently asked questions

Will cutting a tree root kill the tree? Usually not by itself. A root cut far out from the trunk costs the tree some water uptake and it regrows new roots at the cut. The danger rises fast as cuts move toward the trunk: Iowa State Extension says to avoid cutting buttress roots closer than 3 times the trunk diameter, and to consider removing the tree if roots must be cut within 1.5 times the trunk diameter.

How close to a tree can you cut roots? Keep cuts at least 3 times the trunk diameter away from the trunk, measured 3 feet up, and farther whenever you can. A 2025 study of red maples found that trenching 5 times the trunk diameter away still cut the tree’s resistance to bending by about 22 percent, so stability drops well before the tree looks sick.

How big a root can I cut without hurting the tree? Iowa State Extension says to avoid cutting roots over 2 inches in diameter. Oregon State Extension sets the line at 4 inches, because roots that size are likely structural and cutting them risks the tree falling over. Anything bigger, or anything close to the trunk, is a job for an ISA-certified arborist.

How long does it take a tree to die after root damage? It varies widely. The Morton Arboretum says symptoms can show the next growing season or take 2 to 3 years. Iowa State Extension warns that construction damage may not show for 8 to 10 years. Watch for dieback starting at the top of the crown, small or sparse leaves, and sprouts from the trunk.

Should I fertilize a tree after cutting its roots? No. The Morton Arboretum and Purdue Extension both advise against fertilizing a mature tree after root damage unless it shows a real nutrient deficiency. Water the root zone deeply instead, spread 3 to 4 inches of wood chip mulch, and keep vehicles and equipment off the remaining roots.

The planting and care products linked across this site are collected in the Tree Planting and Watering Essentials list on my Amazon storefront.

cutting tree roots tree root damage construction damage to trees critical root zone tree protection zone root pruning trenching near trees